The tutorial takes you through how you can create your very own DIY jet engine using 3D printed components and an Arduino Portenta H7 and a custom carrier board.

Enrico shows how his Infineon TLE94112EL motor controller shield can be put to work through a simple Arduino sketch.

The motor controller is commanded over the Arduino’s serial interface, and will support a serial interface to ROS (Robot Operating System) in the future.

This machine uses a three-phase Dahlander motor, which has three operation modes: stop, half speed, and full speed. The motor uses a special mechanical switch to select the operating mode.

Tronixstuff has a borderline insane tutorial series going, and as of now, 27 chapters have been published. It's essentially the Arduino Bible, but the two most recent additions in particular have ...