Electronic speed controller with arduino project illustrate a physical 3-phase motor driver system. It features high current MOSFETS, dual MOSFET drivers, and an arduino nano. A DIY motor driver board ...

grbl is stepper motor controller firmware for three-axis cnc machines, intended to run on Arduinos with a motor driver add-on board. Engineer in Wonderland cnc-related blogs are indexed here It is the ...

Later, I helped a friend disassemble a Tesla model, and the mass of circuit boards inside was overwhelming—until I drew 5 ...

[Neumi] over on Hackaday.IO wanted a simple-to-use way to drive stepper motors, which could be quickly deployed in a wide variety of applications yet to be determined. The solution is named Ethersweep ...

Here is a tested Arduino project that uses 3 sensor probes as water level indicator with 3 leds and one LCD display + a simple controller that turns on a motor when the water has reached the desired ...

After purchasing the Qu4tro electric skateboard and finding the controller wasn’t quite as good as the skateboard, Timo Brinschein decided to build his very own using a little Arduino hardware and ...

[Gilad] tipped us about his latest project, where he adds plenty of pneumatics and electronics into his wife’s car to remote control it. The brake/throttle pedals are actuated by pistons controlled by ...

Related to my search for reduced motor noise (and thanks to all who have made suggestions – ‘scope avaunt this weekend), is a search for speed stability in that motor*. And to someone who is in love ...

A motor controller shall open all conductors to the motor where not used as a disconnecting means. Mike Holt is the owner of Mike Holt Enterprises (www.MikeHolt.com), one of the largest electrical ...